Drive By Wire throttle kit

Drive By Wire throttle kit - 1 piece
Material: aluminium
Valve diameter: 52-75mm
Actuator speed: 0.07s/60°
Throttle Position Sensor: 0.5V-4.5V, redundant
Colour: silver, black, red, blue, orange anodised

Colours on request: gunmetal, grey, titanium, brown, copper, green 2, green 3, apple green, lime green, blue 2, blue 3, turquoise, violet, gold

Downloads:
Technical Drawing 52mm (Ford 1.6L Eco Boost)
Technical Drawing 55mm
Technical Drawing 60mm
Technical Drawing 65mm
Technical Drawing 67mm (Subaru Impreza)
Technical Drawing 67mm (Subaru BRZ / Toyota GT86)
Technical Drawing 67mm (Honda (F20) S2000)
Technical Drawing 68mm
Technical Drawing 70mm
Technical Drawing 72mm
Technical Drawing 74mm
Technical Drawing 75mm
Throttle Position Sensor Technical Details

The Drive By Wire (DBW) throttle valves are intended as a replacement for standard throttle valves. Compared to standard throttle bodies, AT-Power throttle bodies offer a significantly higher air flow rate and are also lighter. Ideal for high-end sports and racing engines.

AT Power throttle bodies differ from most other throttle bodies on the market in several essential ways. With AT-Power throttle valves, your engine achieves the highest possible efficiency and thus performance.
Patented shaftless design means there is no need for a continuous medium wave. This reduces turbulence and flow losses. Only 0.5% less air flow compared to a throttle without any flap and up to 10% higher air flow compared to conventional throttle flaps with a shaft.
Butterfly design = use of a flap that is as thin as possible, which is aerodynamically optimal and, in addition to the highest possible passage, also enables perfect metering of the flow rate (via gas cable or electronic actuators).

Highest quality and accuracy of fit. Install, coordinate, win.